Installation

SEAT BELT: REAR SEAT OUTER BELT ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY





(a) Check the degree of the tilt when the ELR begins to lock.
(1) Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt while gently pulling the belt.
NOTE:
Do not disassemble the retractor.





(b) Temporarily install the rear seat 3 point type belt assembly with the 2 bolts.
(c) Fully tighten the rear side bolt first, then the front side bolt to install the rear seat 3 point type belt assembly.
For front bolt - Torque: 7.5 Nm (77 kgf-cm, 66 in-lbf)
For rear bolt - Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)





(d) Connect the pretensioner connector and lock the locking button as shown in the illustration.
2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade) Installation
3. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade) Installation
4. INSTALL ROOF SIDE INNER GARNISH LH Installation
5. INSTALL ROOF SIDE INNER GARNISH RH
6. INSTALL REAR SEAT SIDE GARNISH LH Installation
7. INSTALL REAR SEAT SIDE GARNISH RH
8. INSTALL REAR DOOR SCUFF PLATE LH Installation
9. INSTALL REAR DOOR SCUFF PLATE RH
10. INSTALL BENCH TYPE REAR SEATBACK ASSEMBLY Installation
11. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY
12. INSTALL REAR SEAT HEADREST ASSEMBLY
13. INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY Installation
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
15. INSPECT SRS WARNING LIGHT
Inspect the SRS warning light. Diagnosis System