Removal

WIPER AND WASHER: HEADLIGHT CLEANER ACTUATOR: REMOVAL

REMOVAL
HINT:
- Use the same procedures for both the RH and LH sides.
- The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE COOL AIR INTAKE DUCT SEAL Removal
3. REMOVE FRONT BUMPER COVER Removal
4. REMOVE HEADLIGHT ASSEMBLY Removal





5. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY
(a) Remove the 2 screws and headlight washer actuator.
6. REMOVE HEADLIGHT CLEANER HOSE
(a) Disconnect the hose from the headlight cleaner motor and pump.





(b) Using a screwdriver, detach the 5 clamps and remove the hose.
HINT: Tape the screwdriver tip before use.