Flexplate

INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

(b) Apply adhesive to 2 or 3 threads and under the heads of new bolts.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
(c) Temporarily install the front spacer, drive plate and rear spacer with the 8 bolts.





(d) Tighten the 8 bolts uniformly in several steps in the order shown in the illustration.
Torque: 83 Nm (850 kgf-cm, 61 ft-lbf)
NOTE:
Do not start the engine for at least 1 hour after installing.