Removal

AA80E AUTOMATIC TRANSMISSION: PARK / NEUTRAL POSITION SWITCH: REMOVAL

REMOVAL

1. REMOVE NO. 2 ENGINE UNDER COVER
2. REMOVE REAR NO. 1 FLOOR PANEL BRACE Removal
3. REMOVE FRONT CENTER FLOOR BRACE Removal
4. REMOVE FRONT FLOOR COVER CENTER LH
5. REMOVE FRONT FLOOR COVER CENTER RH
6. CONNECT HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) Removal
7. CONNECT HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) Removal
8. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal
9. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR Removal
10. REMOVE AIR GUIDE PLATE OUTSIDE RH Removal
11. REMOVE REAR PROPELLER SHAFT ASSEMBLY Removal
12. DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

(a) Remove the nut and disconnect the floor shift gear shifting rod.
13. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY

(a) Support the automatic transmission assembly with a transmission jack.
14. REMOVE ENGINE REAR MOUNTING MEMBER

(a) Remove the 4 bolts, and disconnect the engine rear mounting member from the body.
15. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Tilt down the automatic transmission assembly.

(b) Disconnect the switch connector.

(d) Using a screwdriver, pry off the lock washer.

(e) Remove the lock nut and lock washer.

(f) Remove the bolt and switch.