Installation

SUPPLEMENTAL RESTRAINT SYSTEM: SEAT POSITION SENSOR: INSTALLATION

INSTALLATION

1. INSTALL SEAT POSITION SENSOR





(a) Using a feeler gauge 1 mm (0.039 in.), install the seat position sensor.
- If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.
- When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
HINT: Be sure that a clearance between the seat position sensor and the seat rail is within 0.6 mm (0.023 in.) to 1.4 mm (0.055 in.).

(b) Using a "torx" socket wrench (T30), tighten the "torx" screw to install the seat position sensor.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
(c) Make sure that a clearance between the seat position sensor and the seat rail is within 0.6 mm (0.023 in.) to1.4 mm (0.055 in.).
(d) Check that there is no looseness in the installation parts of the seat position sensor.
(e) Connect the connector.
(f) Install the seat slide position sensor protector to the seat position sensor.
2. INSTALL FRONT SEAT ASSEMBLY Installation
3. INSTALL FRONT SEAT TRACK REAR INNER COVER Installation
4. INSTALL FRONT SEAT TRACK REAR OUTER COVER Installation
5. INSTALL FRONT SEAT TRACK BRACKET COVER Installation
6. CONNECT FRONT SEAT OUTER BELT ASSEMBLY Installation
7. INSTALL SEAT BELT ANCHOR COVER CAP Installation
8. INSPECT FRONT SEAT ASSEMBLY Installation
9. INSPECT SRS WARNING LIGHT