Installation

SUPPLEMENTAL RESTRAINT SYSTEM: FRONT AIRBAG SENSOR: INSTALLATION

INSTALLATION

1. INSTALL FRONT AIRBAG SENSOR
(a) Check that the engine switch is off.
(b) Check that the battery negative (-) terminal is disconnected.
CAUTION:
After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.





(c) Connect the connector.
(d) Install the front airbag sensor with the 2 bolts.
Torque: 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE:
- If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(e) Check that there is no looseness in the installation parts of the front airbag sensor.
2. INSTALL HEADLIGHT ASSEMBLY Installation
3. INSTALL ENGINE ROOM SIDE COVER Installation
4. INSTALL FRONT BUMPER ASSEMBLY Installation
5. INSTALL COOL AIR INTAKE DUCT SEAL Installation
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
7. PERFORM INITIALIZATION
8. INSPECT SRS WARNING LIGHT
9. INSPECT AND ADJUST HEADLIGHT AIMING
(a) Inspect and adjust headlight aiming Adjustments.
10. INSPECT AND ADJUST FOG LIGHT AIMING
(a) Inspect and adjust fog light aiming Adjustments.