Replacement

TIRE AND WHEEL: TIRE PRESSURE WARNING ECU: REPLACEMENT

REPLACEMENT

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE RADIO RECEIVER ASSEMBLY
HINT: Refer to the instructions for removal of the radio receiver assembly Removal.

3. REMOVE TIRE PRESSURE MONITOR ECU
(a) Disconnect the connector.





(b) Remove the 2 bolts and tire pressure monitor ECU.
4. INSTALL TIRE PRESSURE MONITOR ECU





(a) Install the tire pressure monitor ECU with the 2 bolts.
Torque: 4.5 Nm (46 kgf-cm, 40 in-lbf)
(b) Connect the connector.
5. INSTALL RADIO RECEIVER ASSEMBLY
HINT: Refer to the instructions for installation of the radio receiver assembly Installation.

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

7. REGISTRATION OF TRANSMITTER ID
HINT:
Registration.

8. INSPECT TIRE PRESSURE WARNING SYSTEM
HINT:
Test Mode Procedure.