Installation

2GR-FSE ENGINE CONTROL SYSTEM: ENGINE COOLANT TEMPERATURE SENSOR: INSTALLATION

INSTALLATION

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
(a) Install a new gasket to the sensor.





(b) Install the sensor.
Torque: 20 Nm (204 kgf-cm, 15 ft-lbf)
(c) Connect the sensor connector.
2. INSTALL INTAKE MANIFOLD Installation
3. INSTALL INTAKE AIR SURGE TANK Installation
4. INSTALL THROTTLE BODY Installation
5. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE Installation
6. CONNECT NO. 2 VENTILATION HOSE Installation
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. INSPECT FOR FUEL LEAK Testing and Inspection
9. INSPECT FUNCTION OF THROTTLE BODY On-Vehicle Inspection
10. ADD ENGINE COOLANT Service and Repair
11. INSPECT FOR COOLANT LEAK Testing and Inspection
12. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation
13. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation
14. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation
15. INSTALL FRONT FENDER TO COWL SIDE SEAL LH Installation
16. INSTALL FRONT FENDER TO COWL SIDE SEAL RH Installation
17. INSTALL FRONT UPPER FENDER PROTECTOR LH Installation
18. INSTALL FRONT UPPER FENDER PROTECTOR RH Installation
19. INSTALL V-BANK COVER Installation
20. INSTALL ENGINE ROOM SIDE COVER LH Installation
21. INSTALL ENGINE ROOM SIDE COVER RH Installation
22. INSTALL COOL AIR INTAKE DUCT SEAL Installation
23. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.