Installation

TIRE AND WHEEL: TIRE PRESSURE WARNING RECEIVER (w/ Antenna):

INSTALLATION

1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY





(a) Install the tire pressure warning receiver assembly with the 2 nuts.
Torque: 7.5 Nm (77 kgf-cm, 66 in-lbf)
(b) Connect the connector.
2. INSTALL ROOF HEADLINING ASSEMBLY
HINT: Refer to the instructions for INSTALLATION of the ROOF HEADLINING Installation.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. INSPECT TIRE PRESSURE WARNING SYSTEM
HINT: Test Mode Procedure