Installation

3UZ-FE ENGINE CONTROL SYSTEM: ENGINE COOLANT TEMPERATURE SENSOR:

INSTALLATION

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR






(a) Install a new gasket to the sensor.
(b) Install the sensor.
Torque: 20 Nm (204 kgf-cm, 15 ft-lbf)
(c) Connect the sensor connector.
2. INSTALL INTAKE AIR CONNECTOR PIPE Installation

3. INSTALL NO. 1 AIR CLEANER INLET Installation

4. INSTALL V-BANK COVER Installation

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

7. ADD ENGINE COOLANT Service and Repair

8. CHECK FOR ENGINE COOLANT LEAKS
(a) Check for engine coolant leaks Testing and Inspection.