Installation

BRAKE CONTROL: FRONT SPEED SENSOR: INSTALLATION

INSTALLATION
NOTE: While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.
HINT:
- The front speed sensor is a component of the front axle hub sub-assembly. If the sensor malfunctions, replace the front axle hub sub-assembly.
- The procedures listed below are for the RH side.
- Other than areas where instructions are provided, use the same procedures for the LH side and RH side.

1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY
HINT: The front speed sensor is a component of the front axle hub sub-assembly. If the sensor malfunctions, replace the front axle hub sub-assembly.

(a) Install the front axle hub Installation.
2. CHECK FRONT AXLE HUB BEARING LOOSENESS Front Axle Hub

3. CHECK FRONT AXLE HUB RUNOUT Front Axle Hub

4. INSTALL FRONT DISC Installation

5. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY Installation

6. INSTALL SKID CONTROL SENSOR WIRE






(a) for LH:
Connect the connector (labeled A) to the front speed sensor.
(b) for RH:





(1) Connect the connector (labeled A) to the front speed sensor.
(2) Install the sensor clamp (labeled B) with the bolt (labeled C).
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
(3) Connect the pad wear indicator connector (labeled D).
(c) Install the 2 sensor clamps (labeled E) with the 2 bolts (labeled F).
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
NOTE: Do not twist the sensor wire when installing the clamps.













(d) Install the sensor clamp (labeled G) with the bolt (labeled H).
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
NOTE: Do not twist the sensor wire when installing the clamp.

(e) Attach the sensor clip (labeled I).
(f) Connect the sensor connector (labeled J).
(g) Connect the front fender liner.
7. INSTALL FRONT WHEEL
Torque: 140 Nm (1428 kgf-cm, 103 ft-lbf)
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9. INSTALL COWL TOP VENTILATOR LOUVER RH Installation

10. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

11. CHECK SPEED SENSOR SIGNAL
(a) Check the speed sensor signal Test Mode Procedure.