Installation

MIRROR: OUTER REAR VIEW MIRROR: INSTALLATION

INSTALLATION
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.





1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY
(a) Install the mirror with the 3 nuts.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
(b) Attach the 3 clamps.
(c) Connect the connector.
2. INSTALL FRONT NO. 2 DOOR SERVICE HOLE COVER Installation

3. INSTALL DOOR FRAME GARNISH Installation

4. INSTALL FRONT DOOR TRIM COVER Installation

5. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY Installation

6. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG Installation

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.