Removal

A760E AUTOMATIC TRANSMISSION: TORQUE CONVERTER AND DRIVE PLATE:

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE COOL AIR INTAKE DUCT SEAL Removal

3. REMOVE ENGINE ROOM SIDE COVER LH Removal

4. REMOVE ENGINE UNDER COVER
5. REMOVE NO. 2 ENGINE UNDER COVER
6. DRAIN COOLANT Testing and Inspection

7. DRAIN AUTOMATIC TRANSMISSION FLUID Removal

8. REMOVE NO. 1 REAR FLOOR PANEL BRACE Removal

9. REMOVE FRONT CENTER FLOOR BRACE Removal

10. REMOVE OXYGEN SENSOR Removal

11. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal

12. REMOVE OUTSIDE AIR GUIDE PLATE RH Removal

13. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR Removal

14. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY Removal

15. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH Removal

16. REMOVE STARTER ASSEMBLY Removal

17. REMOVE FLYWHEEL HOUSING SIDE COVER Removal

18. REMOVE DRIVE PLATE & TORQUE CONVERTER CLUTCH SETTING BOLT Removal

19. SEPARATE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY Removal

20. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY Removal

21. REMOVE ENGINE REAR MOUNTING MEMBER Removal

22. SEPARATE CONNECTOR Removal

23. SEPARATE WIRE HARNESS Removal

24. SEPARATE WATER BY-PASS HOSE Removal

25. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY Removal

26. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR Removal

27. REMOVE TRANSMISSION CONTROL SHAFT LEVER RH Removal

28. REMOVE TRANSMISSION OIL COOLER Removal

29. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY Removal

30. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY Testing and Inspection