Installation

A760E AUTOMATIC TRANSMISSION: TORQUE CONVERTER AND DRIVE PLATE:

INSTALLATION

1. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY Installation

2. INSTALL TRANSMISSION OIL COOLER Installation

3. INSTALL TRANSMISSION CONTROL SHAFT LEVER RH Installation

4. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR Installation

5. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY Installation

6. INSTALL WATER BY-PASS HOSE Installation

7. INSTALL WIRE HARNESS Installation

8. CONNECT CONNECTOR Installation

9. INSTALL ENGINE REAR MOUNTING MEMBER Installation

10. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY Installation

11. INSTALL DRIVE PLATE & TORQUE CONVERTER CLUTCH SETTING BOLT Installation

12. INSTALL FLYWHEEL HOUSING SIDE COVER Installation

13. INSTALL STARTER ASSEMBLY Installation

14. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH Installation

15. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY Installation

16. FULLY TIGHTEN NO. 1 CENTER SUPPORT BEARING ASSEMBLY Installation

17. INSPECT AND ADJUST NO. 2 AND NO. 3 JOINT ANGLE Installation

18. INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR Installation

19. INSTALL OUTSIDE AIR GUIDE PLATE RH Installation

20. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation

21. INSTALL OXYGEN SENSOR Installation

22. INSTALL FRONT CENTER FLOOR BRACE Installation

23. INSTALL NO. 1 REAR FLOOR PANEL BRACE Installation

24. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

25. ADD COOLANT Testing and Inspection
26. ADD AUTOMATIC TRANSMISSION FLUID Procedures
27. ADJUST COOLANT Testing and Inspection
28. CHECK FOR ENGINE COOLANT LEAKS Testing and Inspection

29. ADJUST SHIFT LEVER POSITION Adjustments

30. INSPECT SHIFT LEVER POSITION Shift Lever Assembly

31. CHECK FOR EXHAUST GAS LEAKS Installation

32. INSTALL NO. 2 ENGINE UNDER COVER
33. INSTALL ENGINE UNDER COVER
34. INSTALL ENGINE ROOM SIDE COVER LH Installation

35. INSTALL COOL AIR INTAKE DUCT SEAL Installation

36. RESET MEMORY Programming and Relearning