Removal

A960E AUTOMATIC TRANSMISSION: TORQUE CONVERTER AND DRIVE PLATE:

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE COOL AIR INTAKE DUCT SEAL Removal

3. REMOVE ENGINE ROOM SIDE COVER LH Removal

4. REMOVE ENGINE UNDER COVER
5. REMOVE NO. 2 ENGINE UNDER COVER
6. DRAIN COOLANT Testing and Inspection

7. DRAIN AUTOMATIC TRANSMISSION FLUID Removal

8. REMOVE NO. 1 REAR FLOOR PANEL BRACE Removal

9. REMOVE FRONT CENTER FLOOR BRACE Removal

10. REMOVE OXYGEN SENSOR Removal

11. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal

12. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR Removal

13. REMOVE OUTSIDE AIR GUIDE PLATE RH Removal

14. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY Removal

15. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH Removal

16. REMOVE STARTER ASSEMBLY Removal

17. REMOVE FLYWHEEL HOUSING SIDE COVER Removal

18. REMOVE DRIVE PLATE & TORQUE CONVERTER CLUTCH SETTING BOLT Removal

19. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY Removal

20. SEPARATE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY Removal

21. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY Removal

22. REMOVE ENGINE REAR MOUNTING MEMBER Removal

23. SEPARATE CONNECTOR Removal

24. SEPARATE WIRE HARNESS Removal

25. SEPARATE WATER BY-PASS HOSE Removal

26. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY Removal

27. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR Removal

28. REMOVE TRANSMISSION CONTROL SHAFT LEVER RH Removal

29. REMOVE TRANSMISSION OIL COOLER Removal

30. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY Removal

31. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY Testing and Inspection