Installation

BRAKE CONTROL: YAW RATE AND ACCELERATION SENSOR:

INSTALLATION

1. INSTALL YAW RATE AND ACCELERATION SENSOR






(a) Install the yaw rate and acceleration sensor with the 2 bolts.
Torque: 15 Nm (153 kgf-cm, 11 ft-lbf)
- Do not damage the yaw rate and acceleration sensor.
- Make sure that the yaw rate and acceleration sensor is installed securely.

(b) Install the 2 wire harness clamps.
(c) Connect the yaw rate and acceleration sensor connector.
2. INSTALL NO. 2 REAR AIR DUCT (for Automatic Transmission)






(a) Install the No. 2 console box duct with the 2 clips.
3. INSTALL NO. 2 REAR AIR DUCT (for Manual Transmission)






(a) Install the No. 2 console box duct with the clip.
4. INSTALL CONSOLE BOX Installation

5. INSTALL CONSOLE BOX REGISTER ASSEMBLY Installation

6. INSTALL FRONT ASH RECEPTACLE SUB-ASSEMBLY Installation

7. INSTALL REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) Installation

8. INSTALL FRONT CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) Installation

9. INSTALL CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission) Installation

10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission)






(a) Turn the shift knob clockwise and install the shift lever knob sub-assembly.
11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)






(a) Turn the shift knob clockwise and install the shift lever knob sub-assembly.
12. INSTALL NO. 1 UPPER CONSOLE PANEL GARNISH (for Automatic Transmission) Installation

13. INSTALL NO. 2 UPPER CONSOLE PANEL GARNISH (for Automatic Transmission) Installation

14. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION Vehicle Stability Control System (W/ VDIM).

15. INSPECT SENSOR SIGNAL Test Mode Procedure.