Installation

UF1AE TRANSFER: TRANSFER CONTROL SOLENOID:

INSTALLATION

1. INSTALL TRANSFER CONTROL SOLENOID






(a) Install the transfer control solenoid and solenoid lock plate to the transfer upper valve body with the bolt.
Torque: 6.4 Nm (65 kgf-cm, 57 in-lbf)
HINT: Install the solenoid lock plate into the cutout on the transfer control solenoid.

2. INSTALL TRANSFER VALVE BODY ASSEMBLY Installation

3. INSTALL TRANSFER OIL PAN Installation

4. INSTALL TRANSFER DYNAMIC DAMPER Installation

5. INSTALL ENGINE REAR MOUNTING MEMBER Installation

6. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR Installation

7. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation

8. INSTALL HEATED OXYGEN SENSOR Installation

9. INSTALL FRONT CENTER FLOOR BRACE Installation

10. INSTALL REAR NO. 1 FLOOR PANEL BRACE Installation

11. ADD AUTOMATIC TRANSMISSION FLUID Installation

12. CHECK FOR EXHAUST GAS LEAKS