Removal

A760H AUTOMATIC TRANSMISSION: TORQUE CONVERTER AND DRIVE PLATE:

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE COOL AIR INTAKE DUCT SEAL Removal

3. REMOVE ENGINE ROOM SIDE COVER LH Removal

4. REMOVE ENGINE UNDER COVER
5. DRAIN COOLANT Testing and Inspection

6. DRAIN AUTOMATIC TRANSMISSION FLUID Removal

7. REMOVE NO. 1 REAR FLOOR PANEL BRACE Removal

8. REMOVE FRONT CENTER FLOOR BRACE Removal

9. REMOVE OXYGEN SENSOR Removal

10. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal

11. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR Removal

12. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH Removal

13. REMOVE STARTER ASSEMBLY Removal

14. REMOVE FRONT PROPELLER SHAFT ASSEMBLY Removal

15. REMOVE OUTSIDE AIR GUIDE PLATE RH Removal

16. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY Removal

17. REMOVE FLYWHEEL HOUSING SIDE COVER Removal

18. REMOVE DRIVE PLATE & TORQUE CONVERTER CLUTCH SETTING BOLT Removal

19. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY Removal

20. SEPARATE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY Removal

21. SUPPORT AUTOMATIC TRANSMISSION WITH TRANSFER ASSEMBLY Removal

22. SEPARATE ENGINE REAR MOUNTING MEMBER Removal

23. SEPARATE CONNECTOR Removal

24. SEPARATE WIRE HARNESS Removal

25. SEPARATE WATER BY-PASS HOSE Removal

26. REMOVE AUTOMATIC TRANSMISSION WITH TRANSFER ASSEMBLY Removal

27. REMOVE ENGINE REAR MOUNTING MEMBER Removal

28. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR Removal

29. REMOVE TRANSFER DYNAMIC DAMPER Removal

30. REMOVE TRANSMISSION CONTROL SHAFT LEVER LH Removal

31. REMOVE TRANSMISSION OIL COOLER Removal

32. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY Removal

33. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY Testing and Inspection