Installation
A760H AUTOMATIC TRANSMISSION: TORQUE CONVERTER AND DRIVE PLATE:
INSTALLATION
1. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY Installation
2. INSTALL TRANSMISSION OIL COOLER Installation
3. INSTALL TRANSMISSION CONTROL SHAFT LEVER LH Installation
4. INSTALL TRANSFER DYNAMIC DAMPER Installation
5. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR Installation
6. INSTALL AUTOMATIC WITH TRANSMISSION TRANSFER ASSEMBLY Installation
7. INSTALL WATER BY-PASS HOSE Installation
8. INSTALL WIRE HARNESS Installation
9. CONNECT CONNECTOR Installation
10. INSTALL ENGINE REAR MOUNTING MEMBER Installation
11. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY Installation
12. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY Installation
13. INSTALL DRIVE PLATE & TORQUE CONVERTER CLUTCH SETTING BOLT Installation
14. INSTALL STARTER ASSEMBLY Installation
15. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH Installation
16. INSTALL FRONT PROPELLER SHAFT ASSEMBLY Installation
17. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY Installation
18. INSTALL OUTSIDE AIR GUIDE PLATE RH Installation
19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
20. ADJUST SHIFT LEVER POSITION Adjustments
21. INSPECT SHIFT LEVER POSITION Shift Lever Assembly
22. INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR Installation
23. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation
24. INSTALL OXYGEN SENSOR Installation
25. INSTALL FRONT CENTER FLOOR BRACE Installation
26. INSTALL NO. 1 REAR FLOOR PANEL BRACE Installation
27. ADD COOLANT Testing and Inspection
28. ADD AUTOMATIC TRANSMISSION FLUID Procedures
29. ADJUST COOLANT Testing and Inspection
30. CHECK FOR ENGINE COOLANT LEAKS Testing and Inspection
31. CHECK FOR EXHAUST GAS LEAKS Installation
32. INSTALL ENGINE UNDER COVER
33. INSTALL ENGINE ROOM SIDE COVER LH Installation
34. INSTALL COOL AIR INTAKE DUCT SEAL Installation
35. RESET MEMORY Programming and Relearning