Removal

1UR-FSE IGNITION: IGNITION COIL AND SPARK PLUG: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working Service Precautions.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

3. REMOVE COOL AIR INTAKE DUCT SEAL Removal

4. REMOVE ENGINE ROOM SIDE COVER LH Removal

5. REMOVE ENGINE ROOM SIDE COVER RH Removal

6. REMOVE NO. 1 AIR CLEANER INLET Removal

7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal

8. REMOVE SKID CONTROL ECU Removal

9. REMOVE BATTERY Removal

10. REMOVE NO. 1 BATTERY TRAY SUPPORT
11. REMOVE POWER STEERING ECU ASSEMBLY Removal

12. REMOVE BATTERY TRAY






(a) Remove the 2 bolts and battery tray.
13. SEPARATE NO. 1 ENGINE ROOM RELAY BLOCK ASSEMBLY






(a) Remove the 2 bolts and nut.
14. REMOVE WIRE HARNESS CLAMP BRACKET






(a) Remove the 2 wire harness clamps.






(b) Remove the bolt, wire harness clamp bracket and wire harness clamp.
15. REMOVE IGNITION COIL ASSEMBLY






(a) Disconnect the 8 ignition coil connectors.
(b) Remove the 8 bolts.






(c) Using a screwdriver, pry at the cutouts to remove the 8 ignition coils together with the 8 spark plug tube gaskets.
NOTICE:
Do not damage the cylinder head cover when removing the spark plug tube gasket.
HINT:
Tape the screwdriver tip before use.

16. REMOVE SPARK PLUG






(a) Using a 16 mm plug wrench, remove the 8 spark plugs.