Cylinder Head Assembly: Specifications
Cylinder headWarpage
Cylinder head lower side
Standard 0.05 mm (0.0020 in.)
Intake side
Standard 0.08 mm (0.0031 in.)
Exhaust side
Standard 0.05 mm (0.0020 in.)
Warpage
Maximum 0.10 mm (0.0039 in.)
Cylinder head x Cylinder block
1st 36 Nm (367 kgf-cm, 27 ft lbf)
2nd Turn 90°
3rd Turn 90°
for 12 mm head 21 Nm (214 kgf-cm, 15 ft lbf)
Camshaft bearing cap
Refer to article in Service and Repair, Reassembly. [1][2]Reassembly
Camshaft timing gear 79 Nm (806 kgf-cm, 58 ft-lbf)
Intake Manifold
Temporarily install the intake manifold with the 2 nuts and 8 bolts. Then tighten the 2 nuts and 8 bolts uniformly in the order shown in the illustration.
Torque: 21 Nm (214 kgf-cm, 15 ft-lbf)
Exhaust manifold LH & RH
Install the exhaust manifold LH, and install 8 new nuts in the order shown in the illustration.
Torque: 21 Nm (214 kgf-cm, 15 ft-lbf)