DTC Check / Clear

A760E AUTOMATIC TRANSMISSION: ELECTRONIC CONTROLLED AUTOMATIC TRANSMISSION SYSTEM: DTC CHECK / CLEAR

1. CHECK DTC
(a) DTCs which are stored in the ECM can be displayed with the Techstream.
The scan tool can display pending DTCs and current DTCs. Some DTC aren't stored if the ECM doesn't detect a malfunction during consecutive driving. However, the detected malfunction during once driving is stored as pending DTC.
(1) Connect the Techstream to the Data Link Connector 3 (DLC3).
(2) Turn the engine switch on (IG).
(3) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
(4) Confirm the DTCs and freeze frame data and then write them down.
(5) Confirm the details of the DTCs Automatic Transmission System - A760E.
NOTICE:
When simulating a symptom with the scan tool to check for DTCs, use normal mode. For codes on DIAGNOSTIC TROUBLE CODE CHART subject to "2-trip detection logic", perform the following actions.

Turn the engine switch off after the symptom is simulated once. Then repeat the simulation process again. When the problem has been simulated twice, the MIL illuminates and the DTCs are recorded in the ECM.
2. CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Clear.