Installation

2GR-FSE ENGINE CONTROL SYSTEM: ENGINE COOLANT TEMPERATURE SENSOR: INSTALLATION

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
(a) Install a new gasket to the sensor.






(b) Install the sensor.
Torque: 20 Nm (204 kgf-cm, 15 ft-lbf)
(c) Connect the sensor connector.
2. INSTALL INTAKE MANIFOLD Installation

3. INSTALL INTAKE AIR SURGE TANK Installation

4. INSTALL THROTTLE BODY Installation

5. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE Installation

6. CONNECT NO. 2 VENTILATION HOSE Installation

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. INSPECT FOR FUEL LEAK Testing and Inspection

9. INSPECT FUNCTION OF THROTTLE BODY On-Vehicle Inspection

10. ADD ENGINE COOLANT Service and Repair

11. INSPECT FOR COOLANT LEAK Testing and Inspection

12. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation

13. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation

14. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation

15. INSTALL FRONT FENDER TO COWL SIDE SEAL LH Installation

16. INSTALL FRONT FENDER TO COWL SIDE SEAL RH Installation

17. INSTALL FRONT UPPER FENDER PROTECTOR LH Installation

18. INSTALL FRONT UPPER FENDER PROTECTOR RH Installation

19. INSTALL V-BANK COVER Installation

20. INSTALL ENGINE ROOM SIDE COVER LH Installation

21. INSTALL ENGINE ROOM SIDE COVER RH Installation

22. INSTALL COOL AIR INTAKE DUCT SEAL Installation

23. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.