C1364

BRAKE CONTROL: ELECTRONICALLY CONTROLLED BRAKE SYSTEM: C1246/46: Master Cylinder Pressure Sensor Malfunction

DTC C1246/46 - Master Cylinder Pressure Sensor Malfunction

DTC C1281/81 - Master Cylinder Pressure Sensor Output Malfunction (Test Mode DTC)

DTC C1364/61 - Wheel Cylinder Pressure Sensor Malfunction

DESCRIPTION

The master cylinder pressure sensor and the wheel cylinder pressure sensor are built into the brake actuator, and measure the master cylinder pressure and the wheel cylinder pressure sent to the skid control ECU.
DTC C1281/81 can be deleted when the master cylinder pressure sensor sends a master cylinder pressure signal or the Test Mode ends. DTC C1281/81 is output only in the Test Mode.

WIRING DIAGRAM

INSPECTION PROCEDURE
NOTICE:
When replacing the skid control ECU or brake actuator assembly, perform initialization of linear solenoid valve and calibration Programming and Relearning.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU TO BRAKE ACTUATOR ASSEMBLY)

(a) Disconnect the skid control ECU (A13, A15) connectors and brake actuator assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Resistance:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
2. READ VALUE USING TECHSTREAM (MASTER CYLINDER PRESSURE SENSOR)
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Select the Data List mode on the Techstream.

ABS / VSC / TRAC:

(d) Check the output value of the master cylinder pressure sensor on the Techstream display.
OK:
When the pedal is depressed, the voltage displayed on the Techstream increases.
NG -- REPLACE BRAKE ACTUATOR ASSEMBLY
OK -- Continue to next step.
3. READ VALUE USING TECHSTREAM (WHEEL CYLINDER PRESSURE SENSOR)
(a) Connect the pedal effort gauge.
(b) Install the LSPV gauge (SST) and bleed air Service and Repair.
SST: 09709-29018
(c) Connect the Techstream to the DLC3.
(d) Select the Data List mode on the Techstream.

ABS / VSC / TRAC:

(e) Check the output value of the wheel cylinder pressure sensor at each fluid pressure during the Electronically Controlled Brake System control.
Voltage:
Front Wheel Cylinder Pressure Sensor
Rear Wheel Cylinder Pressure Sensor

NG -- REPLACE BRAKE ACTUATOR ASSEMBLY
OK -- Continue to next step.
4. RECONFIRM DTC
(a) Clear the DTC Electronically Controlled Brake System.
(b) Perform the road and braking test.
(c) Check if the same DTCs are recorded Electronically Controlled Brake System.
HINT:
Reinstall the sensors, connectors, etc. and restore the vehicle to its prior condition before rechecking for DTCs.

Result:

B -- END
A -- Continue to next step.
5. CHECK FREEZE FRAME DATA
(a) Check the information code from the Freeze Frame Data memorized when the DTCs (C1246/46 and C1364/61) are stored Freeze Frame Data.
Result:

B -- REPLACE BRAKE ACTUATOR ASSEMBLY
A -- REPLACE SKID CONTROL ECU