Installation

SUSPENSION: FRONT UPPER SUSPENSION ARM: INSTALLATION

1. INSTALL FRONT UPPER SUSPENSION ARM






(a) Install the front suspension upper arm with the 2 bolts.
Torque: 49 Nm (500 kgf-cm, 36 ft-lbf)
2. INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING (for 2WD) Installation

3. INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING (for 4WD) Installation

4. INSTALL ABSORBER CONTROL ACTUATOR (for AVS) Installation

5. INSTALL FRONT SHOCK ABSORBER CAP UPPER (for AVS) Installation

6. CONNECT TIE ROD ASSEMBLY (for 4WD) Installation

7. CONNECT FRONT SUSPENSION UPPER ARM Installation

8. CONNECT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY FRONT (for 2WD) Installation

9. CONNECT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY FRONT (for 4WD) Installation

10. CONNECT SPEED SENSOR FRONT (for 2WD) Installation

11. CONNECT SPEED SENSOR FRONT (for 4WD) Installation

12. INSTALL ENGINE ROOM SIDE COVER
13. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
15. PERFORM INITIALIZATION
Repair Instruction - Initialization
16. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
Front Wheel Alignment