Installation

2GR-FSE ENGINE CONTROL SYSTEM: VVT SENSOR: INSTALLATION

1. INSTALL VVT SENSOR (for Exhaust Side of Bank 2)






(a) Install the sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(b) Connect the sensor connector.
2. INSTALL VVT SENSOR (for Intake Side of Bank 2)






(a) Install the sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(b) Connect the sensor connector.
3. INSTALL VVT SENSOR (for Exhaust Side of Bank 1)






(a) Install the sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(b) Connect the sensor connector.
4. INSTALL VVT SENSOR (for Intake Side of Bank 1)






(a) Install the sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(b) Connect the sensor connector.
5. INSTALL V-BANK COVER Installation

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
7. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.