Installation
AIR CONDITIONING: BLOWER UNIT: INSTALLATION
1. INSTALL BLOWER ASSEMBLY
(a) Install the blower with the 2 claws and screw.
Torque: 3.0 Nm (31 kgf-cm, 27 in-lbf)
(b) Install the blower with the nut.
Torque: 9.8 Nm (100 kgf-cm, 7 ft-lbf)
(c) Connect the connector.
2. INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY Installation
3. INSTALL NO. 2 AIR DUCT Installation
4. INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY Installation
5. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Installation
6. INSTALL MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY Installation
7. INSTALL FRONT PILLAR GARNISH LH Installation
8. INSTALL FRONT PILLAR GARNISH RH Installation
9. INSTALL GLOVE COMPARTMENT DOOR SUB-ASSEMBLY Installation
10. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Installation
11. INSTALL STEERING CONTROL ECU Installation
12. INSTALL INSTRUMENT PANEL NO. 2 UNDER COVER SUB-ASSEMBLY Installation
13. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY Installation
14. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY Installation
15. INSTALL INSTRUMENT PANEL NO. 1 SAFETY PAD SUB-ASSEMBLY Installation
16. INSTALL INSTRUMENT PANEL NO. 1 UNDER COVER SUB-ASSEMBLY Installation
17. INSTALL INSTRUMENT SIDE PANEL LH Installation
18. INSTALL INSTRUMENT SIDE PANEL RH Installation
19. INSTALL COMBINATION METER ASSEMBLY Installation
20. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation
21. INSTALL CONSOLE BOX Installation
22. INSTALL STEERING COLUMN ASSEMBLY
for 2GR-FSE Installation
for 1UR-FSE Installation
23. INSTALL CONSOLE BOX REGISTER ASSEMBLY Installation
24. INSTALL CONSOLE BOX PLATE Installation
25. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation
26. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation
27. INSTALL CONSOLE UPPER PANEL ASSEMBLY Installation
28. INSTALL FRONT CONSOLE UPPER PANEL GARNISH Installation
29. INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY Installation
30. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY Installation
31. INSTALL SPIRAL CABLE WITH STEERING SENSOR Installation
32. INSTALL STEERING COLUMN COVER UPPER
for 2GR-FSE Installation
for 1UR-FSE Installation
33. INSTALL STEERING COLUMN COVER LOWER
for 2GR-FSE Installation
for 1UR-FSE Installation
34. INSTALL STEERING WHEEL ASSEMBLY
for 2GR-FSE Installation
for 1UR-FSE Installation
35. INSTALL STEERING PAD Installation
36. INSTALL STEERING WHEEL NO. 3 COVER LOWER
37. INSTALL STEERING WHEEL NO. 2 COVER LOWER
38. INSTALL FRONT DOOR OPENING TRIM COVER LH Installation
39. INSTALL FRONT DOOR OPENING TRIM COVER RH Installation
40. INSTALL FRONT DOOR SCUFF PLATE LH Installation
41. INSTALL FRONT DOOR SCUFF PLATE RH Installation
42. INSTALL FRONT WIPER MOTOR AND LINK ASSEMBLY Installation
43. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation
44. INSTALL FRONT FENDER TO COWL SIDE SEAL RH Installation
45. INSTALL FRONT FENDER TO COWL SIDE SEAL LH Installation
46. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation
47. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation
48. INSTALL FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY RH Installation
49. INSTALL FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY LH Installation
50. INSTALL ENGINE ROOM SIDE COVER LH Installation
51. INSTALL COOL AIR INTAKE DUCT SEAL Installation
52. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
53. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
54. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.