Cylinder Head Assembly: Specifications

Cylinder head sub-assembly x Cylinder block
(for bank 1 and 2)
1st 36 Nm, 367 Kgf-cm, (27 ft.lbs.)
2nd Turn 90�
3rd Turn 90�
for 14 mm head 30 Nm, 306 Kgf-cm, (22 ft.lbs.)





Cylinder head set bolt
Standard 10.85 to 11.00 mm (0.4272 to 0.4331 in.)
Minimum 10.70 mm (0.421 in.)

Cylinder head sub-assembly
Standard warpage
Cylinder head lower side 0.05 mm (0.0020 in.)
Intake side 0.08 mm (0.0031 in.)
Exhaust side 0.08 mm (0.0031 in.)
Maximum warpage 0.10 mm (0.0039 in)

Intake Manifold





Install a new gasket and the intake manifold with the 4 bolts and 4 nuts.
Torque: 21 Nm (214 kgf-cm, 15 ft-lbf)

Camshaft bearing cap

Refer to article in Service and Repair, Reassembly. Part 2





Camshaft timing gear 100 Nm (1020 kgf-cm, 74 ft lb)

Exhaust Manifold LH & RH





Install the exhaust manifold to the cylinder head with the 6 nuts in the order shown in the illustration.
Torque: 21 Nm (214 kgf-cm, 15 ft-lbf)

NOTICE:
Do not damage the stud bolt when installing the exhaust manifold.