Shifter A/T: Adjustments

U660E AUTOMATIC TRANSAXLE: SHIFT LEVER: ADJUSTMENT

ADJUSTMENT

1. ADJUST SHIFT LEVER POSITION
(a) Move the shift lever to the N position.






(b) Remove the nut and transmission control cable from the control shaft lever.






(c) Align the protrusions of the park/neutral position switch.






(d) Move the slider in the direction indicated by arrow A and pull up the lock piece in the direction indicated by arrow B.
NOTE: Do not damage the boot.





(e) Connect the transmission control cable assembly to the control shaft lever with the nut.
Torque: 13 Nm (130 kgf-cm, 9 ft-lbf)






(f) Push in the lock piece.
NOTE: Firmly push in the lock piece until the slider lock is engaged.

(g) Start the engine and make sure that the vehicle moves forward when moving the lever from the N to the D position and moves rearward when moving it to the R position.
If it becomes hard to move the shift lever, readjust the shift lever position.