Installation

U660E AUTOMATIC TRANSAXLE: TRANSMISSION CONTROL CABLE ASSEMBLY:

INSTALLATION

1. INSTALL NO. 2 SHIFT CABLE GROMMET RETAINER
(a) Pass the control cable from the cabin to the engine compartment.

(b) Install the No. 2 shift cable grommet retainer with the 2 bolts.
Torque: 5.0 Nm (51 kgf-cm, 44 in-lbf)
2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Move the shift lever to the N position.

(b) Install the transmission control cable assembly as shown in the illustration.
HINT :
- Install the floor shift cable with the uneven surface facing up.
- Securely engage the claws of the floor shift cable.

(d) Install the control cable to the control shaft lever with the nut.
Torque: 13 Nm (130 kgf-cm, 9 ft-lbf)

(e) Push in the lock piece of the transmission control cable.
NOTE: Firmly push in the lock piece until the slider lock is engaged.
HINT: After pushing in the lock piece, make sure that the boot is not deformed.

3. INSTALL CENTER AIRBAG SENSOR ASSEMBLY Installation

4. INSTALL NO. 1 AIR CLEANER INLET Installation

5. INSTALL AIR CLEANER CASE SUB-ASSEMBLY Installation

6. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
7. INSTALL AIR CLEANER INLET ASSEMBLY Installation

8. INSTALL AIR CONDITIONING UNIT
HINT: Installation

9. INSTALL ENGINE ROOM SIDE COVER LH
10. INSTALL COOL AIR INTAKE DUCT SEAL Installation

11. INSPECT SHIFT LEVER POSITION Adjustments

12. ADJUST SHIFT LEVER POSITION Adjustments