Installation

SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY:

INSTALLATION

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY
(a) Check that the engine switch is off.
(b) Check that the battery negative (-) cable is disconnected.
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.





(c) Install the center airbag sensor assembly with the 3 bolts.
Torque: 18 Nm (184 kgf-cm, 13 ft-lbf)
NOTICE :
- If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(d) Check that there is no looseness in the installation parts of the center airbag sensor assembly.
(e) Connect the holder (with connectors).
(f) Check that the water-proof sheet is properly set.
2. INSTALL NO. 1 CONSOLE BOX DUCT Installation

3. INSTALL NO. 3 CONSOLE BOX DUCT Installation

4. INSTALL NO. 2 CONSOLE BOX DUCT Installation

5. INSTALL FLOOR CARPET BRACKET RH Installation

6. INSTALL FLOOR CARPET BRACKET LH Installation

7. INSTALL REAR CONSOLE BOX ASSEMBLY Installation

8. INSTALL CONSOLE REAR END PANEL SUB-ASSEMBLY Installation

9. INSTALL CONSOLE BOX CARPET Installation

10. INSTALL CONSOLE BOX POCKET Installation

11. INSTALL UPPER CONSOLE PANEL ASSEMBLY WITH FRONT ASH RECEPTACLE Installation

12. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

13. INSTALL LOWER INSTRUMENT PANEL RH Installation

14. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Installation

15. INSTALL SIDE INSTRUMENT PANEL RH Installation

16. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

17. INSTALL FRONT DOOR OPENING TRIM COVER RH Installation

18. INSTALL FRONT DOOR SCUFF PLATE RH Installation

19. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation

20. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY Installation

21. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation

22. INSTALL SIDE INSTRUMENT PANEL LH Installation

23. INSTALL FRONT DOOR OPENING TRIM COVER LH Installation

24. INSTALL FRONT DOOR SCUFF PLATE LH Installation

25. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
26. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
HINT: Some systems need initialization after reconnecting the cable to the negative battery terminal.

27. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.