Steering Angle Sensor: Service and Repair

REMOVAL

1. FOLLOW PRECAUTION
a. Follow the PRECAUTION.

2. SET RADIO RECEIVER ASSEMBLY TO SHIPMENT MODE
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

4. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
5. REMOVE SWITCH AND VOLUME CASE
6. REMOVE STEERING PAD SWITCH MODULATOR
7. REMOVE STEERING PAD ASSEMBLY
8. REMOVE STEERING WHEEL ASSEMBLY
9. REMOVE SPIRAL CABLE SUB-ASSEMBLY
10. REMOVE TURN SIGNAL SWITCH ASSEMBLY
11. REMOVE STEERING SENSOR

INSTALLATION

1. INSTALL STEERING SENSOR
2. ADJUST CENTER FRONT WHEEL
3. INSTALL TURN SIGNAL SWITCH ASSEMBLY
4. INSTALL SPIRAL CABLE SUB-ASSEMBLY
5. POSITION SPIRAL CABLE
6. INSTALL STEERING WHEEL ASSEMBLY
7. CHECK STEERING WHEEL CENTER POINT
8. INSTALL STEERING PAD ASSEMBLY
9. INSTALL STEERING PAD SWITCH MODULATOR
10. INSTALL SWITCH AND VOLUME CASE
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

12. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

13. CHECK SRS WARNING LIGHT
a. Check the SRS warning light.