Tire Pressure Warning Antenna (For Rear Side)

TIRE PRESSURE WARNING ANTENNA (for Rear Side)

COMPONENTS:

REMOVAL

HINT:
^ Use the same procedures for the RH side and LH side.
^ The procedures listed below are for the LH side.

1. REMOVE WHEEL HUB ORNAMENT SUB-ASSEMBLY
(a) Remove the 10 bolts and ornament.
2. REMOVE REAR WHEEL
(a) Remove the 5 nuts and wheel.





3. REMOVE REAR TIRE PRESSURE WARNING ANTENNA LH
(a) Remove the rear wheel house liner.
(b) Disconnect the connector.





(c) Remove the 2 bolts and tire pressure warning antenna.

INSTALLATION

HINT:
^ Use the same procedures for the RH side and LH side.
^ The procedures listed below are for the LH side.





1. INSTALL REAR TIRE PRESSURE WARNING ANTENNA LH
(a) Install the tire pressure warning antenna with the 2 bolts.
Torque: 7.8 N*m (80 kgf*cm, 69 in.*lbf)





(b) Connect the connector.
(c) Install the rear wheel house liner.
2. INSTALL REAR WHEEL
(a) Install the wheel with the 5 nuts.
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
3. INSTALL WHEEL HUB ORNAMENT SUB-ASSEMBLY
(a) Install the ornament with 10 bolts.
Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
4. REGISTER TRANSMITTER ID
(a) Register the transmitter ID.