Rear

Height Control Sensor (for Rear Side):

HEIGHT CONTROL SENSOR (for Rear Side)

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.




2. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
a. Disconnect the connector.
b. Place matchmarks on the link and bracket.
c. Remove the nut and disconnect the sensor link.




d. Remove the 2 bolts and sensor.

INSTALLATION




1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
a. Install the sensor with the 2 bolts.

Torque: 7.8 N.m (80 kgf.cm, 69 in.lbf)




b. Align the matchmarks on the sensor link and bracket.
c. Install the nut.

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)

d. Connect the connector.

2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
3. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

4. ADJUST HEADLIGHT AIMING