Canada - Interior - Initialization Of Front Seat
BulletinTSB2295
Issue Date
August 04, 2006
Title
INITIALIZATION OF FRONT SEAT POSITION AND SEATBACK ANGLE
Component
GENERAL INFORMATION
Models
'07 SC 430
INTRODUCTION:
This bulletin explains the initialization procedure for the front seat position and the seatback angle on 2007 model year SC 430 vehicles.
To reduce parasitic current draw from the battery during transport and storage, the D.C.C. fuse (15A) has been removed at the assembly plant. As a result of the removal of the D.C.C. fuse, the following will be inoperative:
- Automatic seat adjustment.
- Driving position memory of the front seat.
It is necessary to initialize the front seat position and the seatback angle after the D.C.C. fuse has been installed during Pre-Delivery Service (PDS), or whenever the battery terminal has been disconnected and reconnected.
NOTE:
Please refer to TSB No. 2293, "DCC Fuse Installation During PDS," for more information on fuse installation.
APPLICABLE VEHICLES:
- 2007 model year SC 430 vehicles.
WARRANTY INFORMATION:
INITIALIZATION PROCEDURE:
1. Install the D.C.C. fuse (15A) to the correct position in the Relay Block in the engine compartment with the ignition switch off. (Refer to TSB No. 2293.)
2. Move the seat position control switch forward until a beeping sound is emitted.
3. Move the seatback angle switch forward until a beeping sound is emitted.
4. Move the seat to the rearmost position, recline the seatback all the way back, and check that the seat will move all the way forward.
NOTE:
Initialize the passenger's seat position and seatback angle in the same manner as the driver's seat.