Without Scan Tool
CLEAR DTCa. Clearing individual DTC memory (when clearing the memory of DTCs detected in the past individually)
1. Press the preset switch "5" for 2 seconds or more while "ECHn" is displayed in the service check mode or during the detailed information mode.
HINT:
- A beep sound is emitted once when the DTC memory is completely cleared.
- When the DTC memory is cleared, only the component code (physical address) is displayed for the target component.
- To check DTCs, press the preset switch "1" and perform the service check again.
b. Clearing entire DTC memory (when clearing entire memory of DTCs detected in the past)
1. Start the diagnosis mode after repairing the trouble area.
2. Press the preset switch "5" for 2 seconds or more ("CLR" is displayed at this time).
HINT:
- A beep sound is emitted once when the DTC memory is completely cleared.
- When the DTC memory for all components is cleared, only the component codes (physical address) are displayed.
3. Press the preset switch "1" to perform the service check again, and check that no DTCs are displayed for all the component codes (physical address).
c. Finishing diagnostic mode
1. Press the "DISC" switch for 2 seconds or more, or turn the ignition switch OFF.