Central Control Module: Service and Repair

Network Gateway ECU:

NETWORK GATEWAY ECU

REMOVAL

1. TABLE OF BOLT, SCREW AND NUT
2. SET RADIO RECEIVER ASSEMBLY TO SHIPMENT MODE
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

4. INSPECT CENTER FRONT WHEEL

5. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
a. Remove the instrument panel safety pad.

6. REMOVE STEERING COLUMN ASSEMBLY
7. REMOVE NO.1 INSTRUMENT PANEL PIN
8. REMOVE NO.1 SIDE DEFROSTER NOZZLE DUCT
9. REMOVE NO.2 SIDE DEFROSTER NOZZLE DUCT
10. REMOVE FRONT DEFROSTER NOZZLE
11. REMOVE NO.1 HEATER TO REGISTER DUCT
12. REMOVE NO.3 HEATER TO REGISTER DUCT
13. REMOVE NO.2 HEATER TO REGISTER DUCT
14. REMOVE INSTRUMENT PANEL REINFORCEMENT

15. REMOVE NETWORK GATEWAY ECU
a. Remove the 2 screws and ECU.

INSTALLATION

1. INSTALL NETWORK GATEWAY ECU
a. Install the ECU with the 2 screws.

2. INSTALL INSTRUMENT PANEL REINFORCEMENT
3. INSTALL NO.2 HEATER TO REGISTER DUCT
4. INSTALL NO.3 HEATER TO REGISTER DUCT
5. INSTALL NO.1 HEATER TO REGISTER DUCT
6. INSTALL FRONT DEFROSTER NOZZLE
7. INSTALL NO.2 SIDE DEFROSTER NOZZLE DUCT
8. INSTALL NO.1 SIDE DEFROSTER NOZZLE DUCT
9. INSTALL NO.1 INSTRUMENT PANEL PIN
10. INSTALL STEERING COLUMN ASSEMBLY
11. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
a. Install the instrument panel safety pad.

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
13. PERFORM INITIALIZATION
a. Perform initialization. Testing and Inspection

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.