P0340
DTC P0340 Camshaft Position Sensor Circuit MalfunctionDTC P0345 Camshaft Position Sensor "A" Circuit (Bank 2)
DESCRIPTION
DTC Detection Condition:
The Variable Valve Timing (VVT) sensor consists of a magnet, iron core and pickup coil. The VVT signal plate has 3 teeth on its outer circumference and is installed on the camshaft timing pulley. When the camshafts rotate, changes occur on the camshaft protrusions and in the pickup coil air gaps. These changes cause fluctuations in the magnetic field and generate voltage in the pickup coil.
Each sensor monitors its timing rotor, which is located on the camshaft. The ECM uses the sensor to detect the camshaft angle. The camshaft rotation synchronizes with the crankshaft rotation, and this sensor communicates the rotation of the camshaft timing rotor as a pulse signal to the ECM. Based on the signal, the ECM controls the camshaft positions.
HINT: DTC P0340 and P0345 indicate a malfunction related to the VVT sensor (+) circuit (wire harness (from ECM to VVT sensor) and VVT sensor).
Reference: Inspection using an oscilloscope.
During cranking or idling, check the waveform of the ECM connector.
MONITOR DESCRIPTION
Monitor Strategy:
Typical Enabling Conditions:
Typical Malfunctions Thresholds:
Component Operating Range:
If there is no signal from the VVT sensor even though the engine is running, or if the rotation of the camshaft and the crankshaft is not synchronized, the ECM interprets this as a malfunction of the sensor. This monitor runs for 10 seconds (the first 10 seconds of engine idle) after the engine is started.
Wiring Diagram:
Step 1-2:
Step 3-4:
INSPECTION PROCEDURE
HINT:
- If DTC P0340 is displayed, check the left bank VVT sensor.
- If DTC P0345 is displayed, check the right bank VVT sensor.
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.