Step A

Perform the required repairs as described below.

Step A:

1. Add EPT foam behind the chrome belt molding.

Dimensions: 5 x 5 x 925 mm (0.20 x 0.20 x 36.40 in.)





2. Attach the NEW EPT foam on the front door belt molding (refer to 4 in the following illustration).

3. Replace existing foam (refer to 2 in the following illustration).

A. Remove the original EPT foam (refer to 2 in the illustration above) and replace with NEW EPT foam (from the repair kit) as shown above.

NEW EPT Foam Dimensions: 5 x 10 x 142 mm (0.20 x 0.40 x 5.6 in.).

NOTE:
Make sure there is NO gap between the NEW foam (refer to 2 in the illustration above) and existing foam (refer to 1 & 3 in the illustration above).





B. Attach the NEW foam (refer to 2 in the previous illustration), overlapping the existing foam (refer to 3 in the previous illustration).

NOTE:
The NEW foam (refer to 4 in the previous illustration) MUST be located 1 mm (0.03 in.) from the bottom edge of the molding (see cross section C - C' in the illustration above).

HINT:
When installing foam (refer to 4 in the previous illustration), cut the foam 10 mm (0.3 in.) from the rear edge of the front door belt molding.