Front Airbag Sensor

Front Airbag Sensor:

FRONT AIRBAG SENSOR

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE FRONT BUMPER COVER
a. Remove the front bumper cover.

3. REMOVE HEADLIGHT ASSEMBLY LH
a. Remove the headlight LH.

4. REMOVE FRONT AIRBAG SENSOR LH




a. Remove the 2 bolts and front airbag sensor from the body.
b. Disconnect the connector.

INSTALLATION

1. INSTALL FRONT AIRBAG SENSOR LH




a. Check that the engine switch is off.
b. Check that the cable is disconnected from the battery negative (-) terminal.

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

c. Connect the connector.
d. Install the front airbag sensor with the 2 bolts.

Torque: 9.0 N.m (92 kgf.cm, 80 in.lbf)

NOTE:
- If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

e. Check that there is no looseness in the installation parts of the front airbag sensor.

2. INSTALL HEADLIGHT ASSEMBLY LH
a. Install the headlight assembly LH.

3. INSTALL FRONT BUMPER COVER
a. Install the front bumper cover.

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

6. CHECK SRS WARNING LIGHT
7. ADJUST HEADLIGHT ASSEMBLY LH
a. Adjust the headlight assembly LH.