Rear Power Outlet Socket (For Ottoman)

Rear Power Outlet Socket (for Ottoman):

REAR POWER OUTLET SOCKET (for Ottoman)

REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY




4. REMOVE CONSOLE BOX PLATE
a. Detach the 6 claws and remove the console box plate from the rear console end panel.




5. REMOVE POWER OUTLET SOCKET
a. Detach the 2 claws and remove the outlet socket from the box plate.

INSTALLATION




1. INSTALL POWER OUTLET SOCKET
a. Attach the 2 claws to install the outlet socket to the box plate.




2. INSTALL CONSOLE BOX PLATE
a. Attach the 6 claws of the box plate to the rear console end panel.

3. INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. INSTALL COWL TOP VENTILATOR LOUVER RH

6. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.