Power Outlet Socket (For Ottoman)

Power Outlet Socket (for Ottoman):

Power Outlet Socket (for Ottoman):

POWER OUTLET SOCKET (for Ottoman)

REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE REAR SEAT CONSOLE ARMREST BASE




4. REMOVE POWER OUTLET SOCKET
a. Detach the claw and remove the power outlet socket.

HINT: Open the cover.




5. REMOVE POWER OUTLET SOCKET COVER
a. Detach the 2 claws and remove the power outlet socket cover.




6. REMOVE REAR CIGARETTE LIGHTER COVER (w/ Cigarette Lighter)
a. Remove the cover.

7. REMOVE REAR CIGARETTE LIGHTER ASSEMBLY (w/ Cigarette Lighter)
a. Remove the cigarette lighter knob and element.




b. Using a screwdriver, detach the claw and remove the cigarette lighter socket and retainer.

HINT: Tape the screwdriver tip before use.




8. REMOVE REAR CIGARETTE LIGHTER BEZEL STAY (w/ Cigarette Lighter)
a. Detach the 2 claws and remove the bezel stay.

INSTALLATION




1. INSTALL REAR CIGARETTE LIGHTER BEZEL STAY (w/ Cigarette Lighter)
a. Attach the 2 claws to install the bezel stay.




2. INSTALL REAR CIGARETTE LIGHTER ASSEMBLY (w/ Cigarette Lighter)
a. Attach the claw to install the rear cigarette lighter.




3. INSTALL REAR CIGARETTE LIGHTER COVER (w/ Cigarette Lighter)
a. Install the rear cigarette lighter cover.




4. INSTALL POWER OUTLET SOCKET COVER
a. Attach the 2 claws to install the socket cover.




5. INSTALL POWER OUTLET SOCKET
a. Attach the claw to install the socket.

6. INSTALL REAR SEAT CONSOLE ARMREST BASE
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. INSTALL COWL TOP VENTILATOR LOUVER RH

9. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.