Luggage Door Opening Switch

LUGGAGE DOOR OPENING SWITCH

Luggage Door Opening Switch:

REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE INSTRUMENT SIDE PANEL LH
4. REMOVE NO. 1 INSTRUMENT CLUSTER MOULDING
5. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY





6. REMOVE LUGGAGE DOOR OPENING SWITCH ASSEMBLY
a. Detach the 2 claws and remove the luggage door opening switch.

INSTALLATION

1. INSTALL LUGGAGE DOOR OPENING SWITCH ASSEMBLY





a. Attach the 2 claws and door opening switch.

2. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
3. INSTALL NO. 1 INSTRUMENT CLUSTER MOULDING
4. INSTALL INSTRUMENT SIDE PANEL LH
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. INSTALL COWL TOP VENTILATOR LOUVER RH
7. PERFORM INITIALIZATION
a. Perform initialization.

NOTICE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.