DTC 41

DTC C1741/41 Front Height Control Solenoid Valve RH Circuit Malfunction

DESCRIPTION

DTC Detection Condition:

The front height control valve independently opens and closes paths to the pneumatic cylinder for the front wheel side by receiving signals from the suspension control ECU.

Wiring Diagram:

Step 1-3:

Step 3(Continued)-5:

Step 5(Continued):

INSPECTION PROCEDURE

NOTE:
- Before performing troubleshooting, inspect the connectors of related circuits.
- If DTC C1782/82 (Power Source Voltage Malfunction) is output at the same time, perform troubleshooting for C1782/82 first.
- Before replacing the suspension control ECU, perform all of the following again: 1) symptom simulation; 2) DTC inspection; and 3) intelligent tester or Techstream inspection (Data List or Active Test). If no malfunctions are found in other areas, replace the suspension control ECU.
- If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed.