C1272

DTC C1272/72 Low Output Signal of Front Speed Sensor LH (Test Mode DTC)

DESCRIPTION

DTC Detection Condition (Part 1):

DTC Detection Condition (Part 2):

DTC Detection Condition (Part 3):

The speed sensor detects wheel speed and sends the appropriate signals to the ECU. These signals are used to control the ABS system. This speed sensor contains a sensor IC, which consists of 2 MREs (Magnetic Resistance Element). The speed sensor rotor, which consists of 48 sets of N and S poles that are arranged in a circle, is integrated with the inner race of the hub bearing.

To detect the rotation direction, the output waves are used to determine the relationship of the pulses that are generated by 2 MREs. Upon receiving this signal, the sensor IC outputs a forward or backward wave to the ECU.

DTCs C1271/71 and C1272/72 can be deleted when the speed sensor sends a vehicle speed signal or the Test Mode ends. DTCs C1271/71 and C1272/72 are output only in the Test Mode.

HINT:
- DTC C0200/31 is for the front speed sensor RH.
- DTC C0205/32 is for the front speed sensor LH.

Wiring Diagram:

Step 1-2:

Step 2(Continued)-3:

Step 4-5:

Step 6:

Step 7-8:

Step 8(Continued)-11:

Step 11(Continued):

INSPECTION PROCEDURE

NOTE: When replacing the skid control ECU, perform initialization of linear solenoid valve and calibration. Initialization

HINT: Start the inspection from "CHECK HARNESS AND CONNECTOR- when using the intelligent tester or Techstream and start from "PERFORM TEST MODE" when not using the intelligent tester or Techstream.