B1883

DTC B1883/68 Short to B+ in Seat Cushion Squib RH Circuit

DESCRIPTION

Detection Condition:

The seat cushion squib RH circuit consists of the center airbag sensor and the seat cushion squib RH.

The circuit instructs the SRS to deploy when deployment conditions are met.

These DTCs are recorded when a malfunction is detected in the seat cushion squib RH circuit.

Wiring Diagram:

Step 1-2:

Step 2 (Continued)-3:

Step 4:

Step 4 (Continued)-5:

INSPECTION PROCEDURE

NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

HINT:
- Perform the simulation method by selecting "check mode" (signal check) with the intelligent tester or Techstream.
- After selecting "check mode" (signal check), perform the simulation method by wiggling each connector of the airbag system or driving the vehicle on various types of roads.