Transmission Speed Sensor: Service and Repair

SPEED SENSOR

Components:

REMOVAL
1. REMOVE TRANSMISSION REVOLUTION SENSOR (NT)

a) Disconnect the transmission revolution sensor connector.
b) Remove the bolt and transmission revolution sensor.
c) Remove the O-ring from the transmission revolution sensor.

2. REMOVE TRANSMISSION REVOLUTION SENSOR (SP2)

Sensor Side (Connector Front View):

a) Measure the resistance according to the value(s) in the table.

Standard Resistance:

If the resistance value is not as specified, replace the speed sensor.

2. INSPECT TRANSMISSION REVOLUTION SENSOR (SP2)

Sensor Side (Connector Front View):

a) Measure the resistance according to the value(s) in the table.

Standard Resistance:

If the resistance value is not as specified, replace the speed sensor.

INSTALLATION
1. INSTALL TRANSMISSION REVOLUTION SENSOR (SP2 SENSOR)

a) Coat a new O-ring with ATF and install it to the transmission revolution.
b) Install the transmission revolution sensor with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
c) Connect the transmission revolution sensor connector.

2. INSTALL TRANSMISSION REVOLUTION SENSOR (NT SENSOR)