Secondary Injector Control Module: Service and Repair

REMOVAL

1. REMOVE COOL AIR INTAKE DUCT SEAL
2. REMOVE NO. 1 INLET AIR CLEANER
3. REMOVE NO. 1 ENGINE COVER

4. REMOVE INJECTOR DRIVER




a. Disconnect the 4 connectors from the injector driver.




b. Remove the bolt, 2 nuts and injector driver.

NOTE: Be careful not to drop or strike the injector driver.

INSTALLATION

1. INSTALL INJECTOR DRIVER




a. Install the injector driver with the bolt and 2 nuts.

Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)

NOTE
- Be careful not to drop or strike the injector driver.
- The injector driver is grounded at the bolt and nut. To ensure that it is grounded, clean all oil and foreign matter from the installation areas of the injector driver and engine before installing the injector driver.




b. Connect the 4 connectors to the injector driver.

2. INSTALL NO. 1 ENGINE COVER
3. INSTALL NO. 1 INLET AIR CLEANER
4. INSTALL COOL AIR INTAKE DUCT SEAL