Antenna, Navigation: Service and Repair

Navigation Antenna:

NAVIGATION ANTENNA

REMOVAL

1. PRECAUTION
2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission)
5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)
6. REMOVE UPPER NO.1 CONSOLE PANEL GARNISH (for Automatic Transmission)
7. REMOVE UPPER NO.2 CONSOLE PANEL GARNISH (for Automatic Transmission)
8. REMOVE CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission)
9. REMOVE REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)
10. REMOVE FRONT CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)
11. REMOVE FRONT ASH RECEPTACLE SUB-ASSEMBLY
12. REMOVE CONSOLE BOX REGISTER ASSEMBLY
13. REMOVE CONSOLE BOX
14. REMOVE NO.3 INSTRUMENT PANEL REGISTER ASSEMBLY
15. REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL
16. REMOVE MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY
17. REMOVE LOWER NO.2 STEERING WHEEL COVER
18. REMOVE LOWER NO.3 STEERING WHEEL COVER
19. REMOVE STEERING PAD
20. REMOVE STEERING WHEEL ASSEMBLY
21. REMOVE STEERING COLUMN COVER (for Power Tilt and Power Telescopic)
22. REMOVE STEERING COLUMN COVER (for Manual Tilt and Telescopic)
23. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
24. REMOVE FRONT DOOR SCUFF PLATE LH
25. REMOVE FRONT DOOR OPENING TRIM COVER LH
26. REMOVE SIDE INSTRUMENT PANEL LH
27. REMOVE NO.1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
28. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
29. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY
30. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
31. REMOVE COMBINATION METER ASSEMBLY
32. REMOVE FRONT DOOR SCUFF PLATE RH
33. REMOVE FRONT DOOR OPENING TRIM COVER RH
34. REMOVE SIDE INSTRUMENT PANEL RH
35. REMOVE NO.2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
36. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY
37. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
38. REMOVE FRONT PILLAR GARNISH LH
39. REMOVE FRONT PILLAR GARNISH RH
40. REMOVE NO.1 INSTRUMENT PANEL REGISTER ASSEMBLY
41. REMOVE NO.2 INSTRUMENT PANEL REGISTER ASSEMBLY
42. REMOVE NO.3 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
43. REMOVE FRONT STEREO COMPONENT SPEAKER ASSEMBLY
44. REMOVE NO.2 CONSOLE BOX DUCT (for Automatic Transmission)
45. REMOVE NO.1 CONSOLE BOX DUCT (for Automatic Transmission)
46. REMOVE NO.2 CONSOLE BOX DUCT (for Manual Transmission)
47. DISCONNECT PASSENGER AIRBAG CONNECTOR
48. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY
49. REMOVE NO.3 HEATER TO REGISTER DUCT
50. REMOVE SIDE NO.2 DEFROSTER NOZZLE DUCT
51. REMOVE DEFROSTER NOZZLE ASSEMBLY

52. REMOVE NAVIGATION ANTENNA ASSEMBLY
a. Disengage the 2 clamps.
b. Remove the 2 screws and navigation antenna.

INSTALLATION

1. INSTALL NAVIGATION ANTENNA
a. Install the navigation antenna with the 2 screws.
b. Engage the 2 clamps.

2. INSTALL DEFROSTER NOZZLE ASSEMBLY
3. INSTALL SIDE NO.2 DEFROSTER NOZZLE DUCT
4. INSTALL NO.3 HEATER TO REGISTER DUCT
5. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY
6. CONNECT PASSENGER AIRBAG CONNECTOR
7. INSTALL NO.2 CONSOLE BOX DUCT (for Manual Transmission)
8. INSTALL NO.1 CONSOLE BOX DUCT (for Automatic Transmission)
9. INSTALL NO.2 CONSOLE BOX DUCT (for Automatic Transmission)
10. INSTALL FRONT STEREO COMPONENT SPEAKER ASSEMBLY
11. INSTALL NO.3 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
12. INSTALL NO.2 INSTRUMENT PANEL REGISTER ASSEMBLY
13. INSTALL NO.1 INSTRUMENT PANEL REGISTER ASSEMBLY
14. INSTALL FRONT PILLAR GARNISH LH
15. INSTALL FRONT PILLAR GARNISH RH
16. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
17. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY
18. INSTALL NO.2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
19. INSTALL SIDE INSTRUMENT PANEL RH
20. INSTALL FRONT DOOR OPENING TRIM COVER RH
21. INSTALL FRONT DOOR SCUFF PLATE RH
22. INSTALL COMBINATION METER ASSEMBLY
23. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
24. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
25. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
26. INSTALL NO.1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
27. INSTALL SIDE INSTRUMENT PANEL LH
28. INSTALL FRONT DOOR OPENING TRIM COVER LH
29. INSTALL FRONT DOOR SCUFF PLATE LH
30. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
31. INSTALL STEERING COLUMN COVER (for Manual Tilt and Telescopic)
32. INSTALL STEERING COLUMN COVER (for Power Tilt and Power Telescopic)
33. ADJUST SPIRAL CABLE SUB-ASSEMBLY
34. INSTALL STEERING WHEEL ASSEMBLY
35. INSTALL STEERING PAD
36. INSTALL LOWER NO.3 STEERING WHEEL COVER
37. INSTALL LOWER NO.2 STEERING WHEEL COVER
38. INSTALL MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY
39. INSTALL CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL
40. INSTALL NO.3 INSTRUMENT PANEL REGISTER ASSEMBLY
41. INSTALL CONSOLE BOX
42. INSTALL CONSOLE BOX REGISTER ASSEMBLY
43. INSTALL FRONT ASH RECEPTACLE SUB-ASSEMBLY
44. INSTALL FRONT CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)
45. INSTALL REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)
46. INSTALL CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission)
47. INSTALL UPPER NO.2 CONSOLE PANEL GARNISH (for Automatic Transmission)
48. INSTALL UPPER NO.1 CONSOLE PANEL GARNISH (for Automatic Transmission)
49. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)
50. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission)
51. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
52. PERFORM INITIALIZATION Testing and Inspection

NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal.

53. INSPECT STEERING PAD
54. INSPECT SRS WARNING LIGHT