Vehicle Stability Control System (w/ VDIM)

DTC C1273/73 Low Output Signal of Rear Speed Sensor RH (Test Mode DTC)

DESCRIPTION

DTC Detection Condition:

The speed sensor detects wheel speed and sends the appropriate signals to the skid control ECU. These signals are used for the ABS control system. This speed sensor contains a sensor IC, which consists of 2 MREs (Magnetic Resistance Element). The speed sensor rotor, which consists of 48 sets of N and S poles that are arranged in a circle, is integrated with the inner race of the hub bearing.

To detect the rotation direction, the output waves are used to determine the relationship of the pulses that are generated by 2 MREs. Upon receiving this signal, the sensor IC outputs a forward or backward wave to the ECU.

DTCs C1273/73 and C1274/74 can be deleted when the speed sensor sends a vehicle speed signal or the Test Mode ends. DTCs C1273/73 and C1274/74 are output only in the Test Mode.

HINT:
- DTC C0210/33 is for the rear speed sensor RH.
- DTC C0205/32 is for the rear speed sensor LH.

Wiring Diagram:

Step 1:

Step 1(Continued)-3:

Step 3(Continued)-6:

Step 6(Continued)-7:

Step 8-10:

Step 10(Continued)-12:

Step 13-14:

INSPECTION PROCEDURE

NOTE: When replacing the skid control ECU, perform zero point calibration and store system information. Vehicle Stability Control System (W/ VDIM)